Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0122, P0123, P0125, P0128, P0130, P0131, P0132, P0133, P0134, P0135, P0220, P0452, P0453, P0502, P0601, P0602, P0604, P060D, P060E, P062F, P0641, P1133, P1516, P1621, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
The EVAP canister vent solenoid valve is commanded OFF, open.
The EVAP canister purge solenoid valve is commanded ON, open.
The barometric pressure (BARO) is more than 74 kPa.
The fuel level is between 15-85 percent.
The engine coolant temperature (ECT) and the intake air temperature (IAT) are between 4-30°C (30-86°F) at engine startup.
The ECT and IAT are within 8°C (15°F) of each other at engine start-up.
The throttle position (TP) angle is between 7-35 percent.
The DTC P0446 diagnostic is run once per drive cycle during the EVAP diagnostic test after the above conditions have been met.
The system voltage is between 11-18 volts.
The vehicle speed is less than 137 km/h (85 mph).