Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201 P0202, P0203, P0204, P0220, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
- The ECT Sensor parameter is more than 70°C (158°F).
- The Ignition 1 Signal parameter is more than 11 volts.
- The Fuel Level Sensor parameter is more than 10 percent.
- The Engine Run Time parameter is more than 30 seconds.
- The TP Angle parameter is between 15-56 percent.
- The MAP Sensor parameter is more than 20 kPa.
- The APP Angle parameter is more than 1.2 percent.
- The Loop Status parameter is closed.
- DTC P0140 runs continuously when the above conditions are met.