Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Ignition 1 Signal parameter is more than 11 volts.
The Fuel Level parameter is more than 10 percent.
The TP Angle parameter is between 15-56 percent.
The MAP Sensor parameter is more than 20 kPa.
The APP Angle parameter is more than 1.2 percent.
The Engine Run Time parameter is more than 30 seconds.
DTC P0134 runs continuously when the above conditions are met.