Conditions for Running the DTC

Rich Test Enable

• DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0300-P0304, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
• The ECT Sensor parameter is more than 70°C (158°F).
• The Ignition 1 Signal parameter is more than 11 volts.
• The Fuel Level Sensor parameter is more than 10 percent.
• The Engine Run Time parameter is more than 10 seconds.
• The Loop Status parameter is closed.
• The TP Angle parameter is between 15-50 percent.
• The APP Angle parameter is more than 1.2 percent.
• The MAP Sensor parameter is more than 25 kPa.
• DTC P0132 runs the rich test when the above conditions are met for 4 seconds.

Decel Fuel Cutoff Test Enable

• DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0300-P0304, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
• The Loop Status parameter is closed.
• The Decel Fuel Cutoff is active.
• DTC P0132 runs the decel fuel cutoff test when the above conditions are met for 2.5 seconds.