LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Transmission Control Module (TCM) Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Removing/Installing TCM From Bracket
    GM1548267Courtesy of GENERAL MOTORS CORP.
  1. Install the TCM bracket (5) if previously removed.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the TCM bracket nuts (3).

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. Install the TCM electrical connector (1) to the TCM.
  4. Install the TCM (2) to the TCM bracket (5).
  5. Re-tape the extra length of wires in harness.
    6. Fig 2: Identifying Push-In Retainers From IP Insulator To Instrument Panel
    GM318202Courtesy of GENERAL MOTORS CORP.
  6. Install the I/P lower left closeout panel.
  7. Install the I/P lower closeout panel screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.

    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.

  8. Reset the TAP values. Refer to Transmission Adaptive Functions  .
  9. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals