LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Seal Removal >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Cross Sectional View Of J 41103 & Components
    GM20211Courtesy of GENERAL MOTORS CORP.
  1. Insert the three J 41103-1  puller legs under the Torque Converter Seal (54). See Special Tools .
  2. Insert the J 41103-3  support body over the stator shaft (43). See Special Tools .
  3. Insert the J 41103-2  puller bridge over the J 41103-3  support body. See Special Tools . Connect the J 41103-1  puller legs into the slots on the J 41103-2  bridge. See Special Tools .
    4. IMPORTANT: The puller legs will damage the torque converter seal (54). Discard the torque converter seal (54) after removal.
  4. Tighten the forcing screw on the J 41103-2  puller bridge until the J 41103-1  puller legs remove the torque converter seal (54). See Special Tools .
scientia non olet · About LEMON Manuals