LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Torque Converter Installation >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 21366  Torque Converter Holding Strap

    Fig 1: View Of Turbine Shaft O-Ring
    GM20155Courtesy of GENERAL MOTORS CORP.
  1. Install a new turbine shaft O-ring (41) on the end of the turbine shaft.
    2. CAUTION: The torque converter weighs approximately 65 lbs. Personal injury may result if you lift the torque converter improperly.
  2. Install the torque converter onto the transmission.
  3. Install the J 21366  .
  4. Remove the transmission from the holding fixture.
scientia non olet · About LEMON Manuals