LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Reverse Input and Second Roller Clutch Installation

Reverse Input and Second Roller Clutch Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Reverse Input Clutch Housing
    GM1644729Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The tangs on the reverse clutch housing spline to the tangs on the reaction carrier sun gear and shell assembly.
  1. While rotating the reverse clutch housing (102) in order to align the clutch plates, install the reverse clutch and 2nd roller clutch assembly into the transmission case.
  2. Assemble the reverse clutch thrust washer (101) onto the top of the 2nd roller clutch. The tabs must face down onto the housing.
scientia non olet · About LEMON Manuals