LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Output Shaft Speed Sensor Installation

Output Shaft Speed Sensor Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Vehicle Speed Sensor Components
    GM25656Courtesy of GENERAL MOTORS CORP.
  1. Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).
  2. Clean and dry the vehicle speed sensor (62).
    3. Fig 2: Locating Output Shaft Speed Sensor
    GM20830Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring (63) onto the speed sensor (62).
  4. Install the speed sensor (62) into the transmission case.
    5. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  5. Install the speed sensor stud (61).

    Tighten:  Tighten the speed sensor stud to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals