LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Output Shaft Installation

Output Shaft Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Snap Ring On Final Drive End Of Output Shaft
    GM474281Courtesy of GENERAL MOTORS CORP.
  1. Install a new snap ring (57) into the snap ring groove on the final drive end (small machined diameter) of the output shaft (94).
  2. Install the output shaft (94) into the final drive assembly. Use a mallet in order to install the shaft (94) through the final drive differential gear.
    3. Fig 2: Identifying Snap Ring Into Output Shaft Snap Ring Groove
    GM474279Courtesy of GENERAL MOTORS CORP.
  3. Install a new snap ring (57) into the output shaft snap ring groove.
scientia non olet · About LEMON Manuals