LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Oil Pump Assembly Installation

Oil Pump Assembly Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Oil Pump Shaft & Oil Pump Assembly
    GM1205806Courtesy of GENERAL MOTORS CORP.
  1. Install the oil pump shaft (19) into the oil pump assembly (10).
  2. Install the oil pump assembly (10) and the oil pump shaft (19) onto the control valve body.
    3. Fig 2: Identifying Oil Pump Bolts
    GM1205827Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the eight oil pump bolts (8, 9, 12). Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals