LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Oil Feed Pipes Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission oil filter assembly. Refer to Oil Filter and Seal Replacement 
    2. Fig 1: View Of Oil Feed Pipe Bolts
    GM104550Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil feed pipe bolts.
  3. Inspect the eight oil feed pipe seal rings.
  4. Replace the seal rings only if the seal rings are cut, swollen or damaged.
    5. Fig 2: Identifying Lo & Reverse Band Oil Pipe Assembly Seals
    GM104551Courtesy of GENERAL MOTORS CORP.
  5. Remove the lo and the reverse band oil pipe assembly.
  6. Remove the eight lo and the reverse band oil pipe assembly seals.
  7. Inspect the oil feed pipes for plugged passages, bent pipes, or cracks.
  8. Inspect the oil feed pipe seal rings. Verify the proper location of the seal rings. Replace the seal rings if these are cut, swelled or damaged.
scientia non olet · About LEMON Manuals