LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Oil Feed Pipes Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Lo & Reverse Band Oil Pipe Assembly Seals
    GM104551Courtesy of GENERAL MOTORS CORP.
  1. Install the eight lo and the reverse band oil pipe assembly seals.
  2. Install the lo and the reverse band oil feed pipe assembly onto the transmission.
    3. Fig 2: View Of Oil Feed Pipe Bolts
    GM104550Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Hand start the bolts that attach the oil feed pipe assembly to the transmission.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  4. Install the transmission oil filter assembly. Refer to Oil Filter and Seal Replacement .
    IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  5. Reset the TAP values. Refer to Transmission Adaptive Functions  .
scientia non olet · About LEMON Manuals