LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Low/Reverse Servo Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Assemble the low and reverse servo. Refer to Low and Reverse Servo Assemble and Installation  in Automatic Transaxle 4T40-E/4T45-E-Unit Repair.
    2. Fig 1: View Of Low/Reverse Servo Assembly
    GM588858Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the lo and the reverse band servo cover bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install the oil feed pipe. Refer to Oil Feed Pipes Replacement .
    IMPORTANT: It is recommended that transmission adaptive pressure (TAP) information be reset.
    Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance may be affected as new TAP values are learned.
  4. Reset the TAP values. Refer to Transmission Adaptive Functions  .
scientia non olet · About LEMON Manuals