LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Input Carrier Pinion Gear Clearance Check

Input Carrier Pinion Gear Clearance Check

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Measuring Input Carrier Pinion Gear Clearance
    GM20255Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Replace the carrier if pinion gear clearance is out of specification. The pinion gears are permanently assembled to the carrier and are not serviced individually.
  1. Measure the pinion gear end play for proper clearance. Use a feeler gage. The clearance should be 0.24-0.69 mm (0.01-0.027 in).
  2. Inspect the reaction internal gear and the input carrier assembly for damage or excessive wear. Specifically inspect the condition of the pinion gears, the washers, and the thrust bearings.
  3. Clean and dry each of the components.
scientia non olet · About LEMON Manuals