LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Forward Clutch Support, Low Roller Clutch Assemble

Forward Clutch Support, Low Roller Clutch Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Forward Clutch Support Seals
    GM20239Courtesy of GENERAL MOTORS CORP.
  1. Assemble two new seals (654) on the forward clutch support (656).
    2. Fig 2: View Of Forward Clutch Support On Final Drive Sun Gear Shaft
    GM20237Courtesy of GENERAL MOTORS CORP.
  2. Assemble the forward clutch support (656) onto the final drive sun gear shaft (651).
  3. Assemble the roller bearing (658) onto the forward clutch support (656).
  4. Assemble the parking pawl gear (659) onto the final drive sun gear shaft (651) with the raised inner boss facing up, so that the parking pawl properly engages the teeth on the parking pawl gear.
    5. IMPORTANT: The space between the parking pawl gear (659) and the snap ring (660) is approximately 3 mm (0.12 in).
  5. Assemble the snap ring (660) to the final drive sun gear shaft (651) in order to retain the parking pawl gear (659).
    6. Fig 3: Locating Roller Clutch Assembly On Forward Clutch Support
    GM20235Courtesy of GENERAL MOTORS CORP.
  6. Assemble the lo roller clutch assembly (652) onto the forward clutch support (656). The larger tabs on the cage must face down into the forward clutch support (656). Rotate the cage slightly counterclockwise in order to lock the tabs into the grooves in the forward clutch support (656).
  7. Assemble the thrust bearing (113) onto the forward clutch support (656).
scientia non olet · About LEMON Manuals