LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Floor Shift Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. If the shift control is being replaced, remove the shift control knob. Refer to Floor Shift Control Knob Replacement . If the shift lever is not being replaced, it is not necessary to remove the shift control knob.
  2. Remove the console shift lever bezel. Refer to Console Shift Lever Bezel Replacement in Instrument Panel, Gauges and Console.
  3. Remove the instrument panel storage compartment. Refer to Storage Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gauges and Console.
  4. Fig 1: Control Cable & Control Assembly Lever
    GM1412174Courtesy of GENERAL MOTORS CORP.
  5. Remove the range select lever cable from the shift control.
  6. Fig 2: Removing/Installing Park Lock Cable At Shift Control
    GM1412177Courtesy of GENERAL MOTORS CORP.
  7. Remove the park lock cable from the shift control. Refer to Park Lock Cable Replacement 
  8. Fig 3: Disconnecting/Connecting Electrical Connector
    GM1412179Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the electrical connector.
  10. Fig 4: View Of Shift Control & Nuts
    GM1412180Courtesy of GENERAL MOTORS CORP.
  11. Remove the automatic transmission control nuts.
  12. Remove the automatic transmission control.