LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Floor Shift Control Knob Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Using Flat Bladed Tool To Separate Trim Ring & Shift Knob
    GM1547446Courtesy of GENERAL MOTORS CORP.
  1. Carefully insert a small flat bladed tool (2) between the trim ring (3) and the shift knob (1).
  2. Apply careful downward pressure to the shift knob trim ring (3) to separate the trim ring trim the shift knob. The trim ring (3) will drop down approximately 13.0 mm (0.5 in) exposing the shift knob retaining screw.
    3. Fig 2: Loosening/Tightening Shift Control Knob Screw
    GM1547444Courtesy of GENERAL MOTORS CORP.
  3. Loosen the shift control knob screw (2) approximately 4-5 turns. It is not necessary to fully remove the screw from the shift control knob.
    4. Fig 3: Removing/Installing Shift Control Knob From Shift Control Lever
    GM1547442Courtesy of GENERAL MOTORS CORP.
  4. Remove the shift control knob (2) from the shift control lever.
scientia non olet · About LEMON Manuals