LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Final Drive Assembly Assemble >> Tools Required

Tools Required

WARNING: This page is about a different variant/trim than selected.

J 36850  TRANSJEL™

    Fig 1: Identifying Differential Side & Pinion Gears
    GM20226Courtesy of GENERAL MOTORS CORP.
  1. Assemble the thrust washers (708) onto the differential side gears (709).
  2. Install the differential side gears into the final drive carrier (702).
  3. Assemble the thrust washers (706) onto the pinion gears (707). Retain the thrust washers with J 36850  or equivalent.
  4. With the thrust washers (706) attached, install the pinion gears (707) into the final drive carrier (702).
  5. Rotate the pinion gears (707) into position, and install the pinion shaf (703) through the final drive carrier (702) and through the pinion gears (707).
  6. Position the pinion shaft (703) in order to allow installation of the retaining pin.
    7. IMPORTANT: Using a chisel stake the retaining pin (704) in place.
  7. Install the retaining pin (704) through the final drive carrier (702) and through the pinion shaft (703) in order to retain the pinion shaft (703).
scientia non olet · About LEMON Manuals