Drive, Driven Sprockets and Drive Link Assemble

Tools Required

• J 29569-1  Turbine Shaft Seal Installer. See Special Tools .
• J 29569-2  Turbine Shaft Seal Sizer. See Special Tools .
• J 29829-1  Turbine Shaft Seal Installer. See Special Tools .
• J 29829-2  Turbine Shaft Seal Sizer. See Special Tools .

Fig 1: Expanded View Of Drive Sprocket & Snap Rings
Courtesy of GENERAL MOTORS CORP.
1. Assemble the drive sprocket (37) onto the turbine shaft (39).
2. Retain the drive sprocket with the turbine shaft to drive sprocket snap ring (35).
Fig 2: Identifying Seals On Turbine Shaft
Courtesy of GENERAL MOTORS CORP.
3. In order to assemble three new Teflon seals (33, 40) onto the turbine shaft (39), perform the following procedure:
   1. Slide the J 29569-1  over the large spline of the turbine shaft. See Special Tools .
   2. Coat the J 29569-1  with transmission fluid. See Special Tools .
   3. Use your fingers in order to guide the new Teflon™ seals over the J 29569-1  and into the seal ring grooves on the turbine shaft. See Special Tools .
   4. Remove the J 29569-1  when the seals are in place. See Special Tools .
   IMPORTANT: In order to properly size the seals, keep the J 29569-2  in place for five minutes. See Special Tools .
   5. Size the new Teflon™ seals. Use both halves of the J 29569-2  . See Special Tools .
   6. Repeat steps 3.1 thru 3.6 with J 29829-1  and J 29829-2  on the small splined side of the turbine shaft. See Special Tools .