LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Drive Sprocket Support Installation

Drive Sprocket Support Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Inspecting Converter Seal Drain Holes For Blockage
    GM25500Courtesy of GENERAL MOTORS CORP.
  1. Inspect the drive sprocket support (43) for damage to the stator shaft splines, the journals, the bushings, and the roller bearing.
  2. Inspect the converter seal drain holes for blockage.
    3. Fig 2: Locating Drive Sprocket Support
    GM20213Courtesy of GENERAL MOTORS CORP.
  3. Install the drive sprocket support (43) into the bell housing of the transmission case.
  4. Install the six drive sprocket support bolts (53) into the drive sprocket support (43).
    5. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  5. Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals