Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the battery box. Refer to Battery Box Replacement in Engine Electrical.
- Remove the upper transaxle oil cooler pipe fitting at the radiator.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Position a drain pan under the transaxle cooler pipes.
- Remove the transaxle oil cooler pipe retaining nut from the transaxle.
- Remove the transaxle oil cooler pipe from the transaxle.
- Remove the lower transaxle oil cooler pipe fitting at the radiator.
- Remove the transaxle oil cooler pipe retaining clip from the radiator.
- Remove the transaxle oil cooler pipes from the vehicle.
NOTE:
Allow sufficient clearance around the transaxle oil cooler pipes and around the hoses to prevent damage or wear which may cause fluid loss.