LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Automatic Transaxle - 4T45-E - Introduction (2 Of 2)) >> Repair Instructions >> Automatic Transmission Fluid Pan and Gasket Installation

Automatic Transmission Fluid Pan and Gasket Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Inspecting Oil Pan Gasket
    GM25657Courtesy of GENERAL MOTORS CORP.
  1. Inspect the oil pan (88) for cracks, dents or damage to the gasket sealing surface.
  2. Inspect the gasket (87) for cuts or other damage. The bottom pan gasket is reusable if not damaged.
  3. Clean and dry the bottom pan, gasket and magnet (89).
    4. Fig 2: View Of Bottom Pan & Gasket
    GM20163Courtesy of GENERAL MOTORS CORP.
  4. Install the gasket (87) and bottom pan (88) onto the transmission case.
    5. Fig 3: Identifying Bottom Pan Bolt Locations
    GM20837Courtesy of GENERAL MOTORS CORP.
  5. Install the twelve bottom pan bolts (81).
    6. Fig 4: Identifying Bottom Pan Bolts
    GM20323Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  6. Hand start the bolts.

    Tighten:  Tighten the bottom pan bolts to 14 N.m (124 lb in).

scientia non olet · About LEMON Manuals