Installation Procedure
WARNING: This page is about a different variant/trim than selected.
- Install sealant to the rear cover.Refer to Sealers, Adhesives, and Lubricants for sealant type.Sealers, Adhesives, and Lubricants
- Install the oil guide.
- Install the rear cover.
Tighten: Tighten the rear cover bolts to 25 N.m (18 lb ft).
- Install the left front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
IMPORTANT:
The oil guide only installs in one direction. Ensure the oil guide is completely seated in the gear shafts.
NOTE:
Refer to Fastener Notice
in Cautions and Notices.