LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Sealant Replacement - Lower Crankcase to Engine Block >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
Fig 1: Lower Crankcase, Engine Block And Components
GM1894201Courtesy of GENERAL MOTORS CORP.
  1. Remove the starter motor. Refer to Starter Motor Replacement .
  2. Remove the engine-to-transaxle brace.
  3. Remove the engine oil pan. Refer to Oil Pan Replacement  .
  4. Remove the crankshaft position sensor. Refer to Crankshaft Position Sensor Replacement .
  5. Remove the 3 perimeter bolts.
    IMPORTANT: Do not forget the 2 outside rear bolts.
  6. Remove and discard the crankshaft bearing bolts.
  7. Using the pry points and an appropriate prying tool, gently separate the upper and lower crankcase.
  8. Clean the sealing material from the engine block and lower the crankcase.
scientia non olet · About LEMON Manuals