LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> On-Vehicle Repair Instructions >> Piston, Connecting Rod, and Bearing Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Coat the following parts with engine oil:
    • The piston
    • The piston rings
    • The cylinder bore
    • The bearing surfaces
      • Fig 1: J-43966-1 Installed Into Connecting Rod Bolt Holes
      GM412431Courtesy of GENERAL MOTORS CORP.
  2. Install the piston into its original bore using the J-43966-1  , J 43953  and J 41742  .
  3. Lightly tap the top of the piston with a wooden hammer handle.
  4. When installing the piston and the connecting rod, the stamped mark on the piston must point to the front of the engine.
  5. Hold theJ 43953  firmly against the engine block until all the piston rings have entered the cylinder bore.
  6. Install the connecting rod caps onto their original connecting rods.
  7. Align the numbers placed on the connecting rod and the connecting rod cap during removal.
    NOTE: Refer to Fastener Notice in the Preface section.
  8. Install the new connecting rod bolts and nuts.

    Tighten 

    • On the first pass, tighten the nuts evenly to 25 Nm (18 lb ft).
    • On the final pass, use the J 45059  in order to tighten the nuts an additional 100 degrees.
    Fig 2: Measuring Connecting Rod Side Clearance
    GM465919Courtesy of GENERAL MOTORS CORP.
  9. Measure the connecting rod side clearance with a feeler gage.

    The correct clearance is 0.070-0.370 mm (0.0027-0.0145 in).

  10. Install the cylinder head. Refer to Cylinder Head Replacement  .
  11. Install the oil pan. Refer to Oil Pan Replacement  .
scientia non olet · About LEMON Manuals