LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Indicator
    GM1179604Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the oil level indicator tube O-ring with engine oil supplement.
  2. Install the oil level indicator and the oil level indicator tube into the oil pan.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the oil level indicator tube bracket to the intake manifold bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Install the electrical wiring harness to the oil level indicator tube.
  5. Install the knock sensor wiring clip into the oil level indicator tube.
scientia non olet · About LEMON Manuals