LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Intake Camshaft, Bearing Cap, and Adjuster Removal

Intake Camshaft, Bearing Cap, and Adjuster Removal

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Camshaft And Caps
    GM412170Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove each bolt on each cap one turn at a time until there is no spring tension pushing on the camshaft.
  1. Mark bearing caps to ensure they are installed in the same position.
  2. Remove the intake camshaft bearing cap bolts.
  3. Remove the camshaft bearing caps.
  4. Remove the intake camshaft.
    5. Fig 2: View Of Camshaft Roller Followers
    GM412183Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Keep all of the roller finger followers and hydraulic element adjusters in order so that they can be reinstalled in their respective locations.
  5. Remove the intake camshaft roller finger followers.
    6. Fig 3: View Of Hydraulic Element Lash Adjusters
    GM412185Courtesy of GENERAL MOTORS CORP.
  6. Remove the hydraulic element adjusters.
scientia non olet · About LEMON Manuals