Engine Front Cover and Oil Pump Installation
WARNING: This page is about a different variant/trim than selected.
- Install the engine front cover with a new gasket.
- Install the long water pump bolt.
Tighten: Tighten the water pump bolt to 25 N.m (18 lb ft).
- Install the engine front cover bolts.
Tighten: Tighten the engine front cover bolts to 25 N.m (18 lb ft).
- Install the accessory drive belt tensioner.
- Install the accessory drive belt tensioner bolt.
Tighten: Tighten the bolt to 45 N.m (33 lb ft).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.