LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Mechanical - 2.2L (L61)) >> Repair Instructions >> Off-Vehicle Repair Instructions >> Engine Block Assemble

Engine Block Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Passage Plug, Oil Flow Check Valve & Water Jacket Drain Plug
    GM412447Courtesy of GENERAL MOTORS CORP.
  1. Install the drain plug in the water pump.
  2. Apply sealant P/N 21485278, to the plug before installation.
    3. NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  3. Install the coolant jacket plugs.

    Tighten:  Tighten the coolant jacket plug to 35 N.m (26 lb ft).

  4. Install the rear oil passage plugs.
  5. Apply sealer GM P/N 12346004 (Canadian P/N 10953480) , to the plugs before installation.

    Tighten:  Tighten the oil passage plug to 60 N.m (44 lb ft).

  6. Install the other oil passage plugs.
  7. Apply sealer GM P/N 12346004 (Canadian P/N 10953480), to the plug before installation.

    Tighten:  Tighten the oil passage plugs to 35 N.m (26 lb ft).

    8. Fig 2: View Of Crankshaft Position Sensor
    GM630345Courtesy of GENERAL MOTORS CORP.
  8. Lubricate the crankshaft position sensor O-ring with engine oil.
  9. Install the crankshaft position sensor and bolt.

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    10. Fig 3: View Of Engine Oil Pressure Sensor
    GM630350Courtesy of GENERAL MOTORS CORP.
  10. Install the oil pressure switch.

    Tighten:  Tighten the oil pressure switch to 10 N.m (89 lb in).

    11. Fig 4: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
  11. Install the knock sensor and bolt.

    Tighten:  Tighten the knock sensor bolt to 25 N.m (18 lb ft).

scientia non olet · About LEMON Manuals