Camshaft Cover Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: View Of Camshaft Cover

Courtesy of GENERAL MOTORS CORP.

Assemble the camshaft cover and NEW gasket. Ensure that the gasket is located in the retaining groove in the camshaft cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the cover on the cylinder head and hand start the bolts.
Tighten: Tighten the camshaft cover bolts to 10 N.m (89 lb in).

Fig 2: View Of Front Lift Bracket

Courtesy of GENERAL MOTORS CORP.

Install the front lift bracket and bolt.
Tighten: Tighten the front lift bracket bolt to 25 N.m (18 lb ft).

Fig 3: View Of Rear Lift Bracket

Courtesy of GENERAL MOTORS CORP.

Install the rear lift bracket and bolts.
Tighten: Tighten the rear lift bracket bolts to 25 N.m (18 lb ft).

Fig 4: View Of Camshaft Cover Ground Strap

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ground strap.
Tighten: Tighten the camshaft cover ground strap bolts to 10 N.m (89 lb in).

Fig 5: View Of Spark Plugs

Courtesy of GENERAL MOTORS CORP.

Fig 6: View Of Ignition Coil & Module Assembly

Courtesy of GENERAL MOTORS CORP.

Install the ignition coil and module assembly to the cam cover.
Tighten: Tighten the ignition coil and module assembly bolts to 10 N.m (89 lb in).
Install the cam cover bolts.

Fig 7: View Of Power Steering Blockout Plate

Courtesy of GENERAL MOTORS CORP.

Install the power steering pump and bolts.
Tighten: Tighten the power steering pump bolts to 25 N.m (18 lb ft).