LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying Outlet Resonator/Duct Assembly
    GM898897Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the intake air temperature (IAT) sensor connector.
  2. Loosen the clamp at the air cleaner assembly.
  3. Remove the push-pin attachment from the outlet resonator/duct assembly to support bracket.
  4. Loosen the clamp at the throttle body assembly.
  5. Disconnect the PCV fresh air bent hose at the cam cover.
  6. Remove the outlet resonator/duct assembly.
  7. Disconnect the EI module electrical connector.
    8. Fig 2: View of Ignition Module Housing Assembly With Spark Plug Boots
    GM951506Courtesy of GENERAL MOTORS CORP.
  8. Remove the ignition module attachment bolts.
  9. Remove the ignition module housing assembly with the spark plug boots from the spark plugs.
    10. Fig 3: Installing Spark Plugs
    GM895073Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: To avoid getting water and debris into the spark plug holes, used compressed air and a shop rag to blow out each spark plug hole before plugs are removed.
  10. Remove the spark plugs using a spark plug socket.
scientia non olet · About LEMON Manuals