LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Evaporative Emission Vent Solenoid
    GM927741Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
    IMPORTANT: The evaporative emission (EVAP) vent solenoid is located on the top of the EVAP canister.
  1. Raise the vehicle on a hoist.
  2. IMPORTANT: Take care when removing the EVAP vent solenoid from the EVAP canister. Fuel vapor lines are fragile.
  3. Remove the 3 EVAP canister-to-underbody fasteners and slightly lower the EVAP canister enough to remove the EVAP vent solenoid.
  4. Disconnect the EVAP vent solenoid electrical connector.
  5. Fig 2: View Of EVAP Vent Solenoid
    GM932641Courtesy of GENERAL MOTORS CORP.
  6. Turn the EVAP vent solenoid counter clockwise and remove from the EVAP canister.