LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
    CAUTION: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
    IMPORTANT: The EVAP emissions canister is located under the center of the vehicle. It has 3 EVAP line connections:
    • The EVAP fresh air hose
    • The EVAP purge connection
    • The EVAP vent connection
  1. Raise the vehicle on a hoist. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the EVAP canister fresh air line from the fuel tank fresh air line.
  3. Disconnect the EVAP canister purge line and vent line from the EVAP canister.
    4. Fig 2: View Of EVAP Canister-To-Body Underbody Fasteners
    GM1226414Courtesy of GENERAL MOTORS CORP.
  4. Remove the EVAP canister-to-underbody fasteners.
  5. Disconnect the EVAP vent solenoid electrical connector.
  6. Remove the canister from the vehicle.
scientia non olet · About LEMON Manuals