LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Controls - 2.2L (L61) - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Connect the EVAP vent solenoid electrical connector.
    2. Fig 1: View Of EVAP Canister-To-Body Underbody Fasteners
    GM1226414Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the EVAP canister-to-body underbody fasteners.

    Tighten:  Tighten the EVAP canister nuts to 8 N.m (71 lb in).

    3. Fig 2: View Of Evaporative Emission Canister
    GM1226407Courtesy of GENERAL MOTORS CORP.
  3. Connect the EVAP canister purge and vent lines to the EVAP canister.
    4. Fig 3: View Of EVAP Canister Fresh Air Line
    GM933920Courtesy of GENERAL MOTORS CORP.
  4. Connect the EVAP canister fresh air line to the fuel tank fresh air line.
  5. Lower the vehicle from the hoist.
scientia non olet · About LEMON Manuals