LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transaxle - 4T45-E - Overhaul) >> Off-Vehicle Repair Instructions >> Output Shaft Speed Sensor Installation

Output Shaft Speed Sensor Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Vehicle Speed Sensor Components
    GM25656Courtesy of GENERAL MOTORS CORP.
  1. Inspect the vehicle speed sensor (62) for damage to the sensor, the electrical connector, or the O-ring (63).
  2. Clean and dry the vehicle speed sensor (62).
    3. Fig 2: Locating Output Shaft Speed Sensor
    GM20830Courtesy of GENERAL MOTORS CORP.
  3. Install the O-ring (63) onto the speed sensor (62).
  4. Install the speed sensor (62) into the transmission case.
    5. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the speed sensor stud (61).

    Tighten:  Tighten the speed sensor stud to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals