Output Shaft Removal

Tools Required

• J 6125-1B  Slide Hammer with Adapter
• J 38868  Output Shaft Assembly Remover and Installer

Fig 1: Removing Output Shaft Snap Ring
Courtesy of GENERAL MOTORS CORP.
1. Remove the snap ring (57).
Fig 2: Installing J 6125-1B & J 38868 On Output Shaft
Courtesy of GENERAL MOTORS CORP.
2. Install the J 6125-1B  and J 38868  on the output shaft (94).
3. Use a screw driver to pry up on the shaft to take up the slack, then pull up on the slide hammer.