LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Automatic Transaxle - 4T45-E - Overhaul) >> Off-Vehicle Repair Instructions >> Oil Feed Pipes Assemble

Oil Feed Pipes Assemble

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Locating Oil Feed Pipe Inspection Areas
    GM20833Courtesy of GENERAL MOTORS CORP.
  1. Inspect the oil feed pipes (83) for plugged passages, bent pipes, or cracks.
  2. Inspect the oil feed pipe seal rings (82) in order to verify the proper location of the seal rings (82).
    3. IMPORTANT: The oil feed pipe seals are glued into place during initial assembly. If you must replace a seal ring, be sure to thoroughly clean any residual glue from the oil feed pipes.
  3. Replace the seal rings (82) only if they are cut, swelled or damaged.
  4. Clean and dry the oil feed pipes.
    5. Fig 2: View Of Oil Feed Pipe Assembly
    GM20166Courtesy of GENERAL MOTORS CORP.
  5. Install new oil feed pipe seal rings (82) if necessary.
  6. Retain any newly installed oil feed pipe seal rings (82) with J 36850  or equivalent.
  7. Install the oil feed pipe assembly (83) onto the transmission case (51).
    8. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  8. Install the four oil feed pipe bolts (81). Hand start the bolts.

    Tighten:  Tighten the bolts to 12 N.m (9 lb ft).

scientia non olet · About LEMON Manuals