Manual Shift Shaft, Detent Lever, and Park Lock Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the manual shaft to transmission case pin (803).
- Remove the manual shaft and detent lever assembly (806) by pushing the manual shaft into the transmission case (51). The parking lock actuator assembly (807) remains attached to the detent lever until you remove the manual shaft and detent lever assembly.
- Remove the manual shaft seal (809) from the case (51).
IMPORTANT:
The parking lock actuator assembly (807) remains attached to the manual shaft and detent lever until the assembly is removed.
NOTE:
Do not damage the case bore during removal of the manual shift shaft seal.