Input Internal Gear, Forward Clutch Hub Disassemble
WARNING: This page is about a different variant/trim than selected.
- If the thrust washer (109) has not been removed, remove the thrust washer (109) from the forward clutch hub (577).
- Remove the input internal gear to forward clutch hub assembly snap ring (578).
- Remove the forward clutch hub (577) from the input internal gear (560).
- Inspect the input internal gear (560) for damage or excessive wear.
- Inspect the forward clutch hub (577) splines for damage or excessive wear.
- Inspect the bushing and the thrust washer (109) for damage or excessive wear.
- Clean and dry all of the components.