Manual Gear Range Selection
WARNING: This page is about a different variant/trim than selected.
The shift solenoids control the upshifts in the manual gear ranges.
Perform the following tests using 10-15 percent throttle angle.
Reverse
- With the vehicle stopped, move the gear selector to REVERSE.
- Slowly accelerate the vehicle.
- Verify that there is no noticeable slip, noise or vibration.
Manual First
- With the vehicle stopped, move the gear selector to FIRST.
- Accelerate the vehicle to 32 km/h (20 mph).
- Verify the following:
- No upshifts occur
- The TCC does not apply
- There is no noticeable slip, noise, or vibration
Manual Second
- With the vehicle stopped, move the gear selector to SECOND.
- Accelerate the vehicle to 57 km/h (35 mph).
- Verify the following:
- The 1-2 shift occurs
- The 2-3 shift does not occur
- There is no noticeable slip, noise, or vibration
Manual Third
- With the vehicle stopped, move the gear selector to THIRD.
- Accelerate the vehicle to 64 km/h (40 mph).
- Verify the following:
- The 1-2 shift occurs
- The 2-3 shift occurs
- There is no noticeable slip, noise, or vibration