No Reverse or Slips in Reverse
WARNING: This page is about a different variant/trim than selected.
No Reverse, Slips in Reverse
| Checks | Causes |
|---|---|
| Reverse Clutch | No apply or slipping |
| Piston and Seal Assembly (457) | Binding, cracked, or leaking |
| Inner Seal (456) | Plugged orifice |
| Clutch Plates (460-463) | Worn friction or broken splines |
| Snap Ring (459, 464) | Out of position |
| Housing (454) | Cracked, plugged feed holes, or broken tangs |
| Housing Retainer and Ball Assembly | Missing or out of position |
| Springs (458) | Binding |
| Reverse Clutch Fluid Routing | Fluid leak or restriction |
| Driven Sprocket Support (95) |
|
| Channel Plate and Gasket, and Valve Body, Gaskets, and Channel Plate | Porosity, fluid leak across the channels, misalignment, damage, or fluid restriction |
| Low and Reverse Band and Servo | No apply or slipping |
| Servo Piston (69) | Broken or binding |
| Servo Piston Seals (71, 72) | Leaking |
| Servo Pin (67) and Springs (66, 68) | Binding |
| Servo Cover (73) | Broken, loose, or leaking |
| Low and Reverse Band (111) | Broken, worn, or out of position |
| Anchor Pin (64) | Broken |
| Fluid Feed Tubes (83) |
|
| Transmission Case (1) | Porosity, fluid leak, or restriction |
| Shift Linkage | Disconnected or misaligned |
| Manual Valve (800) and Link (802) | Disconnected or misaligned |
| #1 Checkball | Missing, no low band fluid |
| Fluid Level | Low |
| Fluid Pressure | Low Refer to High or Low Line Pressure . |