Automatic Transmission Oil Cooler Flushing and Flow Test (SA9165T): Clean-up
WARNING: This page is about a different variant/trim than selected.
- Disconnect the water supply hose from the SA9165T and bleed any remaining air pressure from the flusher tank. See Special Tools .
- Remove the fill cap from the SA9165T and return any unused flushing solution to its container. See Special Tools . Rinse the SA9165T with water. See Special Tools . Do not store the SA9165T with flushing solution in it. See Special Tools .
- After every third use, clean the SA9165T as described in the instructions included with the tool. See Special Tools .
- Dispose of any waste water/solution and transmission fluid in accordance with local regulations.