Diagnostic Aids
WARNING: This page is about a different variant/trim than selected.
- Since many things can cause a stalling condition use the snapshot taken of DTC P1599 to compare the values taken when the DTC set to the Typical Scan Data Value table. Look for conditions that could have caused the stall and how long ago the stall occurred. If other DTCs are set, especially DTC P0336, diagnose those DTCs first.
- DTC P1599 may be set if the engine speed drops below 400 RPM, near stall, and then recovers.
- If the condition is intermittent, refer to Intermittent Conditions .
- Verify drive did not induce the stall condition.
DTC P1599
| Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Diagnostic System Check - Vehicle? | - | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
- | Go to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC Information | Go to Symptoms - Engine Controls |