Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Power Enrichment parameter is active.
The Ignition 1 Signal parameter is more than 11 volts.
The Loop Status parameter is closed.
The Fuel Level Sensor parameter is more than 10 percent.
The Engine Run Time parameter is more than 10 seconds.
DTC P1137 runs continuously when the above conditions are met for 5 seconds.