Conditions for Running the DTC

WARNING: This page is about a different variant/trim than selected.

DTCs P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0122, P0123, P0125, P0128, P0201, P0202, P0203, P0204, P0220, P0300, P0315, P0336, P0442, P0446, P0452, P0453, P0455, P0496, P0506, P0507, P0601, P0602, P0604, P0606, P0641, P0651, P1516, P1621, P1680, P1681, P2101, P2120, P2125, P2135, P2138, P2176 are not set.
The ECT Sensor parameter is more than 70°C (158°F).
The Engine Speed parameter is between 1,000-3,500 RPM.
The Ignition 1 Signal parameter is more than 11 volts.
The Engine Run Time parameter is more than 200 seconds.
The Loop Status parameter is closed.
The TP Angle parameter is between 6-60 percent.
The EVAP Purge Solenoid DC parameter is more than 35 percent.
The Fuel Level Sensor parameter is more than 10 percent.
The MAP Sensor parameter is between 10-104 kPa.
The above conditions are met for 0.75 second.
DTC P1133 runs once per drive cycle when the above conditions are met.