Removal Procedure

WARNING: This page is about a different variant/trim than selected.

Fig 1: Clutch Pedal Assembly, Studs & Nuts

Courtesy of GENERAL MOTORS CORP.

Fig 2: Pushrod & Clutch Pedal

Courtesy of GENERAL MOTORS CORP.

First design. Remove the retaining clip in order to disconnect the clutch master cylinder pushrod from the clutch pedal.

Fig 3: Clutch Position Switch & Clutch Pedal

Courtesy of GENERAL MOTORS CORP.

Second design. Disconnect the clutch master cylinder pushrod from the clutch pedal.

Fig 4: Clutch Pedal Assembly & Bolt

Courtesy of GENERAL MOTORS CORP.

Fig 5: Clutch Pedal Assembly, Studs & Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the clutch position switch from the clutch pedal assembly by sliding upward.
Remove the bolt from the clutch pedal assembly.