LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Pedal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Clutch Pedal Assembly, Studs & Nuts
    GM986926Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the bolt to the clutch pedal assembly.

    Tighten:  Tighten the clutch pedal assembly bolt to 10 N.m (89 lb in).

    2. Fig 2: Clutch Pedal Assembly & Bolt
    GM986941Courtesy of GENERAL MOTORS CORP.
  2. Install the clutch position switch by sliding downward.
    3. Fig 3: Pushrod & Clutch Pedal
    GM925443Courtesy of GENERAL MOTORS CORP.
  3. Connect the clutch master cylinder pushrod to the clutch pedal assembly and install the retaining clip.
    4. Fig 4: Clutch Position Switch & Clutch Pedal
    GM925454Courtesy of GENERAL MOTORS CORP.
  4. Second design. Install the clutch master cylinder pushrod to the clutch pedal.
    5. Fig 5: Clutch Pedal Assembly, Studs & Nuts
    GM986926Courtesy of GENERAL MOTORS CORP.
  5. Install the nuts to the clutch pedal assembly studs.

    Tighten:  Tighten the clutch pedal assembly nuts to 23 N.m (17 lb ft).

scientia non olet · About LEMON Manuals