LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Manual Transmission Clutch System) >> Repair Instructions >> Clutch Actuator Cylinder Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Clutch Actuator Cylinder & Transaxle
    GM1145263Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Excessive amounts of lubricant on the input shaft splines can contaminate the clutch disc and cause clutch shudder.
  1. Lightly lubricate the inside diameter of the bearing with input shaft lubricant P/N 21005995 or equivalent.
  2. Install the clutch actuator cylinder (1) to the transaxle.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the clutch actuator cylinder bolts.

    Tighten:  Tighten the bolts to 10 N.m (89 lb in).

  4. Install the transaxle. Refer to Transmission Replacement in Manual Transmission - Getrag-5 Speed.
    5. Fig 2: View of Clutch Master Cylinder Hose and Components
    GM1870387Courtesy of GENERAL MOTORS CORP.
  5. Install the clutch master cylinder hose retainer clip.
  6. Connect the clutch master cylinder line to the transaxle by pushing it in until it seats.
  7. Bleed the clutch hydraulic system. Refer to Hydraulic Clutch Bleeding .
scientia non olet · About LEMON Manuals