LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2006 >> Vue Red Line, AWD >> Repair and Diagnosis (Single Page) >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brakes >> Repair Instructions >> Master Cylinder Replacement >> Removal Procedure

Removal Procedure

CAUTION: Refer to Brake Fluid Irritant Caution in Cautions and Notices.
NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice in Cautions and Notices.
    Fig 1: Disconnecting/Connecting Brake Fluid Level Sensor Electrical Connector
    GM931316Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the electrical connector from the brake fluid level sensor.
    2. Fig 2: Disconnecting/Connecting Brake Pipes From Master Cylinder
    GM931327Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the brake pipes from the master cylinder.
    3. IMPORTANT: Install a rubber cap or plug to the exposed brake pipe fitting ends in order to prevent brake fluid loss and contamination.
  3. Plug the open brake pipe ends.
    4. Fig 3: Removing/Installing Master Cylinder
    GM926593Courtesy of GENERAL MOTORS CORP.
  4. Remove master cylinder mounting nuts.
  5. Remove the master cylinder from the vehicle.
  6. Drain the master cylinder reservoir of all brake fluid.
scientia non olet · About LEMON Manuals